Starting at: $378.00

These are built the same as the Standard Model except for the inner tube is 2"x2" square. The same suggestions and recommendations for the Standard Model would apply to this model as well.

This product is made with 1.5" diameter CREW (Cold Rolled Electric Welded) round tubing and 2"x2" square tubing. Both are .120" wall. The sliders will be delivered in an unfinished/unpainted state, but are 100% ready to be welded to your vehicles frame. No further modifications are required. Just clean the paint off the frame, clamp the sliders to the vehicle and weld away. No legs to be cut and fit, no further fabrication required, this product is 100% ready to be installed upon arrival. This saves YOU a ton of money and time with your local fabricator/welder at the time of install. The exception is the front leg on the 1979-1995 models will be shipped long and then need to be cut to fit as there was a lot of production variance with those frames back in the day. The scab plates will be included and are already installed on all of the other legs (79-95) and welded on all of the other models (96+) at the time the sliders are built. Saving you even more installation cost and time.

Please Choose:

Sold Out
Copyright © 2017 Sonoran Steel. Powered by Zen Cart
Photo Album New Mexico Backroads - Jake Quinones Radflo